Loading Fasteners; Dimensions Of Staples And Nails That Can Be Used; Maintenance - Jula Meec tools 154-091 Operating Instructions Manual

Loading fasteners

1. Plug in the power cord and start the tool the power switch.
2. Press the nose of the tool against the place where the fastener is to be put. Push the trigger lock
forwards and press the trigger. One fastener is fired. Release the trigger. The trigger lock
automatically returns to the home position. This completes the firing cycle. To fire several fasteners
in one operation, do not release the trigger lock and continue firing the tool instead.
3. The trigger lock automatically returns to the home position when you release it. The trigger cannot
be pressed and the tool is disabled.
4. The striking power is adjusted with the knob (4): Turn in the direction of the arrow for higher striking
power, or in the opposite direction for lower striking power.

Dimensions of staples and nails that can be used

Staples (mm)
NOTE: Switch off the tool and unplug the power cord before maintenance and/or cleaning.

The staple gun is maintenance-free.

Clean the staple gun regularly, preferably every time is has been used. Use a dry, lint-free cloth.

Do not use water or detergents.
Jula reserves the right to make changes. In the event of problems, please contact our service
department.
www.jula.com
ENGLISH

MAINTENANCE

20
Nails (mm)