Related Manuals for 3DUpFitters Prusa i3 MK2
Summary of Contents for 3DUpFitters Prusa i3 MK2
- Page 1 Prusa i3 MK2/3/3S & MMU2/2S Enclosure Kit Installation Manual 1.3 April, 2019 Copyright 2018 3DUPfitters...
- Page 2 This page intentionally left blank. Copyright 2018 3DUPfitters...
-
Page 3: Before You Start
Before you Start Is This Manual for Your Kit? This installation manual covers the R3 enclosure design for the Prusa i3 MK2/3 enclosure and the larger MMU2S enclosure. If you have an older version of the enclosure please contact us if you have a question and need an older manual. - Page 4 Don’t Panic If You See This! If you can’t see through the plastic, please don’t panic! What you’re seeing is just the plastic or paper protective covering. You, dear customer, are way too smart to think the plastic is flawed and then call and email us over and over again leaving increasingly irate messages.
- Page 5 Assemble Panels 1. The Front Door Each of the corners on the enclosure will be held together by the connectors pictured below. There are only two versions L and R, which can be identified by the letters stamped on the inside. The opposite connectors are identical, i.e.
- Page 6 There is also a mid-panel corner connector to attach on the right side. Locate the magnetic latches and use the wood screws to attach them to the latch mounts. Hand tighten and make sure they’re secure, but do not over tighten or they may strip.
- Page 7 2. Attach Left Side The left panel is distinguishable by its small hole for a cable grommet, in addition to having “left side” written on it. Insert the grommet as pictured before attaching the front of the left- side to the door frame. 3.
- Page 8 the enclosure. If attaching the fan by itself use 16mm cap head screws; if attaching the filter and fan use M4 cap head 30mm or 40mm screws depending on the depth of the particular fan. The air filter should look like this after being attached. Note that it's easier to insert the screws from the inside, and put the nuts next to the filter housing.
- Page 9 supply, both cooling the power supply and heating the air as it enters. Even without a fan, the power supply is still cooler this way because one side is exposed to colder air. The right side panel is a little tricky to configure because Prusa now has used two different sizes of power supply.
-
Page 10: Spool Holder
much tolerance in the placement of the off/on switch and power cable plug, so you’ll have to get it pretty close. This will make it easier to turn off and on and provide the best seal so that heat won’t escape. 7. - Page 11 9. MMU2/MMU2S The Prusa enclosure for the MMU2/MMU2S is taller so there is room inside for the MMU2/2S unit. It also contains 4 extra grommeted exit holes to run the PTFE tubes from the filament spools or detangler box to the top-mounted multi-material extruder.