How To Use - Panasonic FV-KTB2T61HK Operation/Installation Instructions Peration/Installation Instructions

How to use

How to use
Insert the plug into the power socket. With a beep, all the buttons on the control panel light up and last for about
2 seconds, and then go out.
 Power on/off Power on/off
Touch the button, all the buttons light up (the
white lowlight) and the unit enters standby state.
 Fan speed setting Fan speed setting
In standby state, touch the
fan speed button being touched turns white highlight, and the fan speed buttons not being touched turns white
lowlight). The fan speed can be switched between "LOW", "MEDIUM", "HIGH" and "ULTRA HIGH" by touching
fan speed buttons.
When touching the fan speed button showing white highlight in the working state of the fan, the fan will stop
running with a beep.
 Ultra high speed Ultra high speed
In standby state, touch the
running for 3 minutes in ULTRA HIGH mode, the fan enters a running state of HIGH mode with a beep; touch
the button again within 3 minutes, the fan stops working with a beep.
 Light on/off Light on/off
In power-off state, touch the
on; touch the button again, the LIGHT button goes out with a beep, and the light goes out.
In power-off state or working state of fan, touch the
beep, and the light turns on; touch the
goes out.
 Automatic vent Automatic vent
In standby state, touch the
VENT button fl ashes, and the fan enters a "LOW" speed running state. The fan will stop running automatically
after running at "LOW" speed for 3 minutes, and the AUTOMATIC VENT button turns highlight. The fan
automatically enters the low-speed state and runs for 3 minutes every 6 hours.
Touch
will start for the automatic vent function after the fan stops running at "LOW", "MEDIUM", "HIGH" or "ULTRA
HIGH" speed.
Touch the button when the fan is running. The AUTOMATIC VENT button turns white highlight. A timing
cycle of 6 hours will start after the fan stops running at "LOW", "MEDIUM", "HIGH" or "ULTRA HIGH" speed.
 Latency switch function Latency switch function
Touch the button when the fan is on. The
the "Power-off latency" function. The fan will stop running automatically after running at low speed for 3
minutes.
→ If the light is on, touch the
→ If the automatic vent function is on, touch the
the latency comes to an end.
→ If you touch the
at a corresponding fan speed.
→ If you touch the
enter the power-off state.
6
button to set the fan speed (the
button, the backlight of the button fl ashes with a beep. After the fan has been
button, the LIGHT button turns white highlight with a beep, and the light turns
button again, the LIGHT button turns white lowlight, and the light
button, the automatic vent function turns on with a beep, the AUTOMATIC
to turn on the fan when the automatic vent function is on. A new timing cycle of 6 hours
button. The light will go out when the latency comes to an end.
button during the latency, the latency function will turn off and the fan will run
button during the latency, the current latency function will be canceled and the unit will
button turns white highlight, and the other buttons turn
button, the LIGHT button turns white highlight with a
button fl ashes with a beep, and the system starts to perform
button. The automatic vent function will not turn off when
button turns white highlight, the