Preparing For First Time Use - Waterwise 8500 Use & Care Manual

WATERWISE
Kettle Indicator
If the kettle is removed during a cycle, the unit will shut off immediately. The On light
will blink continuously if kettle is not correctly positioned.
Filter Status Indicator/Filter Change Indicator
Carbon
Filter Indicator
ON
AM
DEL AY
PM
CARAFE
FILTER
Start/Stop Hour Minute Delay
On

PREPARING FOR FIRST TIME USE

1. Set Purifier on a level countertop or table.
2. Remove kettle from its receptacle.
3. Remove kettle cover by twisting counterclockwise, then lift.
4. Wash inside of kettle with soap and water, rinse and fill the kettle with ordinary tap
water to the Max line.
Compartment
Carbon
Filter
Housing
The Carbon Filter Indicator shows
four status bars to indicate filter life
(fig. 2). Four bars indicate a new
filter and zero bars indicate that the
filter needs to be changed. In
addition to the bars the Filter
indicator will flash in the display
when the filter needs to be changed.
To reset filter status, press and hold
the Delay button for 7 seconds.
5. Replace the cover onto the
Carbon
kettle. Twist clockwise to
lock. Plug the kettle into the
Cover
base receptacle.
6. Wash and rinse carafe and lid
with soap and water.
IMPORTANT: Before using
7.
Carbon
Filter
carbon filter, rinse the filter
with purified water for 30
seconds so it is wet on all
surfaces. If filter ever dries
out as a result of not using the
purifier, remove and rinse so
it is wet on all surfaces.
6
8. The carbon filter is packed in a separate plastic bag. Remove the cover of the carbon
filter housing located inside the carafe lid. Remove carbon filter from bag and place
into housing. Replace cover on housing, and replace lid on carafe (fig. 3).
9. Place the carafe on the base unit, and plug the power cord into wall outlet.
10. For Model 8500,
press Reset
button to turn the
Purifier on
(fig. 4 Model
8500). Run one
batch of water
into the carafe.
11. For Model 8800,
Kettle
press the Start/
with Cover
Stop button to
turn Purifier on
(fig. 4 Model
8800). Run one
batch of water
into carafe.
Reset
12. Let unit cool at
least 30 minutes.
Steam can cause
severe burns.
13. Unplug kettle
from base unit
and rinse well.
14. Discard the first
batch of water
which may have
some harmless
carbon fines
(very fine black
particles) in it
from manufac-
Kettle
turing and/or
with Cover
packaging.
15. Your Purifier is
now ready for use.
PURIFIER MODEL 8500/8800 USE & CARE GUIDE
Model 8500
Carafe
with Cover
Base
Unit
Reset Button
Model 8800
"Start/Stop"
Button
Carafe
with Cover
Base
Unit
7