Tinkerine Studio Ditto PRO Setup & Operation Manual page 6

Step 5
Loading the Filament
Remove the spool of filament from the packaging and place it on the spool holder. Take the end of the filament from the spool and insert it into
the guide tube. Make sure the filament spool spins clockwise as the filament feeds into the guide tube.
Loading
When installing filament, thread the loose end through
the filament guide tube.
Loading the Filament
Guide Tube
Spool Holder
Have a frim grip on the loose end of the filament when installing or
removing the spool from the printer. Letting go of the loose end before it is
secured may cause it to coil back and become tangled. These tangles are not
easily spotted, and may cause problems during printing.
For long term storage, retract and remove the filament from the printer. PLA
filament can become brittle over time as it is exposed to UV and moisture.
Store opened spools of filament inside the original packaging or in a sealed
bag with a desiccant packet.
The use of third-party filament will void the warranty on your DittoPro 3D Printer.
Removing
When removing filament, thread the loose end
through the storage holes on the spool.
5