Electrolux EUF27393X User Manual page 34

34 electrolux
Warning! It must be possible to
disconnect the appliance from the
mains power supply; the plug must
therefore be easily accessible after
installation.
ELECTRICAL CONNECTION
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
REAR SPACERS
Inside the appliance you find two
spacers which must be fitted as shown
in the figure.
Slacken the screws and insert the spacer
under the screw head, then retighten the
screws.
DOOR REVERSIBILITY
Before carrying out any operations, remove
the plug from the power socket. To change
the opening direction of the door, proceed
as follows:
• To carry out the following operations, we
suggest that this be made with another
person that will keep a firm hold on the
doors of the appliance during the opera-
tions.
• Open the door with the appliance in the
upright position. Unscrew the screws and
remove the upper door plastic trim.
• Remove the little plastic cover from the
door plastic trim and refit on the opposite
side (d).
• Lay down the appliance back side down.