Table of Contents
Advertisement
Balco WaterJet
Cleaning Models
Cleaning Process
The cleaning process consists of different methods, depending on the size of the model, how delicate it
is, and the amount and location of the support material.
Use the following methods for finishing the models you are handling.
Removing Excess Support Material by Hand
While wearing protective gloves, break away the excess support material on the outside of the model. For
delicate models, use a toothpick, pin or small brush after dipping the model in water.
Removing Support Material with the WaterJet
For most models, the most efficient way to remove support material is by using the high water pressure,
using the jet or spray nozzles.
Jet Nozzle
Use the jet nozzle like a scalpel to cut and trim large support-structure areas. The jet nozzle provides
higher water pressure and is suitable for—
• large models without thin walls or fragile sections
• clearing support material from cavities, pipes, tubes and cylinders
Examples of models suitable for cleaning with the jet nozzle are: engine blocks and shoe soles.
Note:
The jet nozzle is not suitable for cleaning models made from flexible materials (such as
™
™
Tango
and Agilus30
) and their digital materials. Using it could leave noticeable
marks on the model.
Cleaning Models
20
Advertisement
Table of Contents
