Table of Contents
Advertisement
Balco WaterJet
Connecting the Water Supply
To connect the water supply:
1. Prepare a garden hose (supplied).
2. Connect the garden hose to the water inlet of the WaterJet.
3. Connect the other side of the garden hose to the cold water tap.
Connecting the Drain
To connect the drain:
1. Prepare—
• two 40-mm 90°elbows (supplied)
• two short 40-mm drain pipes (supplied)
• a drain hose
• waste collector (round bucket inserted in the square bucket)
2. Connect a drain pipe to the water outlet under the WaterJet cabinet.
3. Connect a 40-mm 90°elbow to the drain pipe and connect a drain pipe to the elbow.
4. Connect a 40-mm 90°elbow to the drain pipe and connect another drain pipe to the elbow.
5. Place the waste collector under drain pipe. The drain pipe empties into the waste collector.
6. Connect a drain hose between the water outlet on the waste collector and the building drainage
system.
Caution:
Lack of water or insufficient water pressure can cause the pump to operate improperly,
overheat, or fail. Read the instructions that come with the water pressure pump.
Figure 13 Water supply connections
Installation
18
Advertisement
Table of Contents
