1. Manuals
  2. Brands
  3. Twister Display Manuals
  4. Play Sets & Playground Equipment
  5. EASY STRIKER
  6. Set-up and safety instructions

Twister Display EASY STRIKER Set-Up And Safety Instructions

Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EASY STRIKER and is the answer not in the manual?

Questions and answers

Related Manuals for Twister Display EASY STRIKER

Summary of Contents for Twister Display EASY STRIKER

  • Page 2 Description Quantity Trailer Park Deluxe Model Bell Light Kit Mallet Steel Slide/Puck 3 3/4” Spacer 3 1/4” Spacer 1/2” X 1 1/2” Hex Head Bolt 1/2” X 3” Hex Head Bolt 1/2” X 5” Hex Head Bolt 1/2” X 7” Hex Head Bolt 1/2”...
  • Page 3 (#5 is for Trailer Deluxe units only.) 5. As you face the bottom of the Easy Striker place the tail-light marked “road side” on the left side light bracket, and place the light marked “curb side” on the right side light bracket. Pull out enough cable so that it will extend about two feet beyond the end of the trailer hitch.
  • Page 4 Note: occasionally the mallet will bounce off the side of the rubber pad, so make sure the spectators are kept clear of this area. 4. If the Easy Striker moves or “walks” during use, drive 4 stakes through the 4 holes on the sides of the unit.
  • Page 5 8. Do not leave the unit unattended. 9. Do not allow anyone to climb on the EASY STRIKER. 10. When towing EASY STRIKER, always use a safety chain and tongue pin. 11. Always use the safety chains to secure the support legs when in tow.

Table of Contents