D-Link DAP-3315 Quick Installation Manual page 4

STEP 3: Connect Grounding Wire
A grounding wire is recommended to
4
protect your device from lightning strikes
and the buildup of static electricity.
STEP 4: Connect the AP to Your Network
PoE Injector
POE
C
LAN
B
Router or Switch
POWER IN
This product uses a proprietary PoE design
and can only be used with the included PoE
injector.
A. Connect the Ethernet cable (connected
to the AP in STEP 1) from the AP to the
"POE" port on the PoE Injector.
B. Connect an Ethernet cable from a router/
switch or PC to the "LAN" port on the
PoE Injector.
C. Attach the power cord to the PoE
Injector, and attach it into an electrical
outlet.
4  D-Link DAP-3315 Quick Install Guide
AP
A
LAN (PoE)
Computer
Configuration
If you are configuring the AP locally, connect
a PC to the PoE Injector "DATA IN" port using
an Ethernet cable.
A. Assign a static IP address to your PC
which is in the same network segment
with the device. As the default IP address
of this unit is 192.168.0.50, you may
choose any address from 192.168.0.1 to
192.168.0.254, except 192.168.0.50.
B. Open a web browser and go to
http://192.168.0.50. Enter admin as your
username and leave the password blank to
log into the web UI. Now you can configure
the AP via web UI.