Table of Contents
Advertisement
1. Press Automation > Z-Wave Setup
2. At the Z-Wave device, press the Function Key (depending on the device being added).
3. Follow the on-screen messages until "Device added successfully" is displayed.
4. To rename a device (see below), press the device and press Edit Name.
5. To verify activation, on the controller, press Back
Changing the Device Name/Icon
As a device is enrolled, many devices learn in as a default icon and name. To change the name and/or icon of the device (from
the Z-Wave Device Management Screen) press the device and press Device Setup.
Dimmable Light
On/Off Light
NOTE: Controllers cannot be edited, only Binary, Multilevel switches and Water Valves.
Create Scenes – Define Up to 30 Scenes
The Scene feature is used to control a single device, or multiple devices based on pre-set "Conditions," "Triggers," and
"Actions." When a trigger/condition occurs, the defined action is executed. To program a scene:
1. Press Automation > Scene Setup
2. Press the Scene Name field > enter a Name > OK.
3. Add the "Condition," "Trigger," and "Action" that you want to occur (see below). After each selection press Save !!
Note: Determine if you need a Condition. The Condition is a 'condition' set to occur prior to a trigger event. See example below.
Example: Turn the lights on when the system disarms, but only at night.
(Condition): "only at Night" – Set TIME Condition (enter Start Time/ Duration or Sun Set/Sun Rise).
(Trigger): when the "system disarms" – Set the trigger to SECURITY: Disarm.
(Action): Turn the "lights ON" – Set the Action to LIGHT: ON.
Scene Rules
• Triggers and Conditions include: Time setting Occurrence/Days/Start Time, Security mode Disarm/Night/Away/Stay/Away
Secured, Thermostat setting Above/Below/Temperature Value, Door Unlocked/Locked/ Code Unlocked Status, Garage
Door Opened/Closed, Water Valve Opened/Closed, and Zones Restore/Alarm/Fault.
• Actions include choosing Security mode Disarm/Night/Away/Stay/Disarm With Code (enter User Code), Thermostat
setting Set Mode/Set Energy/Set Point, Door Unlocks/Locks, Garage Door Open/Close, Water Valve Open/Close,
Recording (List the camera's and choose the camera which will record [see "Camera" section above], and choose the email
address(es) you wish to send to and create a custom message.
NOTE: Each Trigger event can have up to 5 Actions.
Secondary Keypad
After all Z-Wave devices have been enrolled into the Primary Keypad (Controller #1), device information can be transferred to a
Second Keypad (Controller #2). Keep the controllers within 10 feet of each other.
1. On Controller #1: Press Automation > Z-Wave Setup.
2. On Controller #2: Press Z-Wave Primary
Secondary
.
3. On the Primary Controller (#1): Press Add;
4. On the Secondary Controller (#2): Press Add.
Display & Audio Setup
1. Press Setup; slide the Brightness / Volume bar up or down to change settings > Yes.
2. Press Disp & Audio
3. Press Chime, Voice or Voice Chime operating mode (when using Security option only).
4. To clean the controller screen, press Clean Screen > Continue, or press Cancel to exit.
NOTE: Panic keys are inoperable in while the Clean Screen option is performed.
> Add Device
; wait 30 seconds. Press Refresh
Z-Wave Device Icon Options
Garage
Sprinkler
Pool
> Add
.
. (Lower right side of screen.) Press Yes, to change this controller to
> highlight the field for each option and use the Up/Down arrows to select the desired settings.
.
Water Valve
Siren
- 4 -
; the new device is displayed.
Shade
Sounder
Fan
Advertisement
Table of Contents
