Table of Contents
Advertisement
User Setup – Add, Delete, Edit a User
Each user must be assigned a name with a corresponding 4-digit user code in order to gain access to various features and
functions.
Press Setup > System > User Setup > Add User > press each field and enter the appropriate information; press Save when
done.
Follow this procedure for deleting and editing users.
Night Setup - Change Arming Modes
The Night function can be set to arm the system in one of five arming modes. To change the arming mode, press Setup >
System > Advanced Setup > Night Setup: choose from:
Away – Stay – Instant (default) – Maximum – Night (Residential Only)
Arming the System – Away, Stay, Night
You can arm the system in one of three arming modes: Away, Stay, and Night.
AWAY – Press to arm when no
one is staying on the premises.
Protects all programmed perimeter
and interior protection zones.
IMPORTANT: If you return to your home or business and the main burglary sounder is on, DO NOT enter the premises, but call
the police from a nearby safe location. If you return to your home or business after an alarm has occurred and the main
sounder has shut itself off, the controller beeps rapidly upon entering, indicating that an alarm has occurred during your
absence. LEAVE IMMEDIATELY and CONTACT THE POLICE from a nearby safe location.
To Arm the System: Press SECURITY
Notes:
1. If Quick Arm is not enabled in your system, a message to enter your User Code is received.
2. When the system is armed for Stay, Night Stay and Instant mode, Tuxedo beeps 3 times.
3. When the system is armed for Away and Maximum mode, you will hear steady beeps then rapid beeping during the last 10
seconds of Exit Delay (if programmed by the installation company).
4. For CP-01 installations, Maximum Mode cannot be used.
To Arm Multiple Partitions: Press Security
Notes:
1. A user may have access to some or all of the available partitions.
2. If the user code is accepted, the system displays the partitions that the user has access to.
3. If any zones are bypassed "Faulted Zones" (
Disarming the System
To disarm the system when already in the premises press Disarm > enter your 4-digit user code.
To disarm the system when entering the premises enter your 4-digit user code.
To disarm Multi-Partitions - From the Home screen, press Security > Arm Multi-Partition
enter your 4-digit user code.
Display Faulted Zones / Bypass Zones
How to Display Faulted Zones – press Security
How to Bypass Zones - press Security
Notes:
1. Some systems do not allow you to bypass fire, carbon monoxide or emergency zones. On certain fire control systems, a
specified user may be allowed to bypass fire, carbon monoxide and system zones if the user was enabled by your system
installer.
2. Limits apply as to how many zones can be bypassed at one time. These limits are ten zones on residential systems and five
zones on commercial systems.
STAY - Press to arm when you are staying
home, but might expect someone to use the
entrance door later. Protects all programmed
perimeter zones, while bypassing the interior
protection zones.
.
> Arm Multi-Partition
) is displayed on this screen.
>
Faulted Zones
> More Choices
- 2 -
NIGHT - Press to arm when you are staying
home and would like to arm only a portion of
your interior zones (i.e. arming the basement
motion detectors, but not those on the
upstairs level.)
.
.
> Show Zones
.
> Disarm
;
Advertisement
Table of Contents
