Specifications; Part Number; Electric Specifications; 4-3.Mechanical Specifications - Fenwal F11-Y1 Series Operation & Instruction Manual

4. Specifications

4-1. Part Number

4-1-1. Detector
(1) Name of item:
(2) Type:
4-1-2. Mounting Base
(1) Name of item:
(2) Type:

4-2. Electric specifications

(1) Rating:
(2) Range of Working Voltage:
(3) Current consumptions
(4) Set up for receiving
the Alarm signals:
(5) State Indication LED:
(6) Self Check Function
(Sensitivity revise):
(7) Address:
(8) Power off Time:
(9) Mounting Base:
(10) Compatible Control Panels: FC1 (For details, refer to the user's manual for the control unit.)

4-3.Mechanical specifications

4-3-1. Detector
(1) External form:
(2) Main material:
(3) Color:
(4) Mass:
4-3-2. Mounting Base
(1) External form:
(2)Main material:
(3) Color:
(4) Mass:
Photoelectric smoke detector
F11-Y1-xx ("xx" means Address. It is on Address seal.)
Mounting Base
FBR-Y
DC24V 0.5mA（Be supplied by the control unit. No polarity.）
DC16.0V～DC30.0V
(at DC24V): 0.35mA or less at Normal supervision
0.45mA or less at Alarm mode
5％/m (Nominal)
Red LED (blinking)
Normal supervision
Alarm mode
Trouble mode
Trouble mode gives priority over the Alarm mode.
The Detector revise own sensitivity changes automatically once
a day. Use of Environment and Dirty and Degradation of Optics
parts cause of sensitivity changes.
Limit the amount of sensitivity revision come and failure.
Addresses are stored in EEPROM. If EEPROM has problem,
Detector will be trouble state.
Turn off the power on again until 60 seconds margin over time.
FBR-Y
φ28×H47mm
ABS, PBT (UL-94V-0)
Beige
Approximately 20g
φ28×H10mm
ABS (UL-94V-0)
Beige
Approximately 10g
State of LED
10 seconds interval
2 seconds interval
Off (not blinking)
ES1103
頁
10
730110 K0