Installation step:
1.
Loosen 2 sides screws.
2.
Adjust the angle to 90°.
3.
Open the 2 sides screws and place them properly.
4.
Open the electrical box.
5.
Loosen the wire screws and place them properly.
6.
Remove the luminaire holder and place it properly.
7.
Select the appropriate mounting hole position and tap to break the hole. Use a pencil to mark the hole in
the mounting wall.
8.
Drilling with a diameter of 6.0mm and a depth of 28mm.
9.
Insert the expansion tube into the hole and tap the wall horizontally.
10. The wire passes through a hole at the bottom of the electrical box.
11. Install the screw + flat gasket + washer in turn at the bottom of the electrical box.
12. Brown:L Blue:N Yellow Green:
Note:The lenth for yellow green wire is 5cm longer than brown and blue wire.
13. Insert the male side of the socket into the female side, and install the luminaire in reverse order
according to disassembly steps.
3.
Installation diagram
Adjustment angle range:0-90°
L×W×H(mm)
182×228×105mm
3