Advertisement
2.
Vibration and noise reduction
To reduce the influence of vibration and noise: limit working hours, use settings for lower
vibration and noise emissions and wear personal protective equipment. Observe the
following points to minimise vibration and noise exposure:
ATTENTION:
practice cutting logs on a sawhorse or frame.
1.
Use the product only in accordance with its design and instructions.
2.
Ensure that the product is in good condition and well maintained.
3.
Use the correct accessories and ensure that they are in good condition.
4.
Hold the product firmly but not tightly by the handles provided.
5.
Maintain the product according to these instructions and keep it well lubricated.
6.
Plan your working hours according to these instructions to spread a higher load
over a longer period.
3.
Emergency
Familiarise yourself with the use of the product by reading this manual completely. Make a
note of the safety instructions and follow them carefully.
This will help you prevent risks and hazards.
a)
Always be careful when using the product so that you can identify and react to
hazards early. Quick intervention can prevent serious injury and property damage.
b)
Switch off the product and disconnect it from the power supply if problems occur.
Have the product repaired by Kogan.com, if necessary, before reusing the product.
4.
Residual risks
Even if you operate this power tool correctly, there are always residual risks. The following
hazards may occur in connection with the construction and design of this power tool:
a)
Injuries and material damage caused by flying parts.
b)
Hearing damage if you do not wear suitable hearing protection or use the power
tool for a long period.
c)
Damage to health resulting from hand/arm vibrations if the power tool is used for
an extended period or is not properly operated and maintained.
It is recommended that a first-time user should at least
Advertisement
