Advertisement
•
Always use the supplied charger and observe manufacturer charging
requirements.
•
Battery performance is best when within normal room temperature (5°C-20°C).
•
Batteries need to be charged before use.
•
Do not leave the gimbal near heat sources such as a furnace, heater, or the inside
of a vehicle on hot days.
•
Store the stabiliser in a dry environment and never store the stabiliser in any
environment with a temperature of over 60°C.
•
Do not leave the stabiliser unused for too long after it has been completely
discharged to prevent over-discharge of battery. This may result in battery
damage and permanent damage to the product.
CAUTION:
•
The stabiliser is a high -precision control device; damage may be
caused to stabiliser if it is dropped or subject to external force, which
may result in malfunction.
•
Make sure the rotation of stabiliser axes is not blocked by external
force when the stabiliser is powered on.
•
The stabiliser is not waterproof or water-resistant. Prevent contact
with liquid of any kind
•
It is recommended to use a dry cloth for cleaning.
•
Protect the stabiliser from dust and sand during use.
Note:
•
Hold the stabiliser's handle still when it is powering up to ensure it starts up
successfully.
•
Make sure the batteries are fully charged before each time of use.
•
Discharge the battery to 40%~65% if it will not be used for over 10 days. This can
greatly extend the overall battery life.
•
Charge and discharge the battery completely once every 3 months to keep it
active.
Advertisement
