Secure Access; Secure Defense; Quick Start Guide - Vaultek LifePod Instruction Manual

Secure Access: How to open your Vaultek
Keypad: The 4 digit capacitive keypad responds quickly for access and has a built-in proximity
sensor that lights up the keypad when the lock pad is touched.
See page 05 for more information.
IMPORTANT! Before entering your master code you need to
wake the safe by placing your finger on the lock pad so all the
keys light up RED.
Key: Two keys are provided for manual access to the safe in the event the battery dies.
IMPORTANT! The manual key can not lock LifePod
Secure Defense: How your Vaultek
Anti-Impact Latch: Built to withstand forceful
impacts.
High Impact Polymer: Engineered to be
extremely strong and impact resistant.
Anti-Pry Design: The interior channels and
gasket form a seal around the inner chamber
making it difficult for tools and other small
objects to penetrate.
03 Vaultek ®
LifePod
® ®
.
®
LifePod keeps people out
® ®
Security Tether: An included security tether
and security cable can be used to secure
LifePod ® to a stationary object.
Security Sleep Mode: Activates when (6)
consecutive incorrect keypad entries are
entered. LifePod will not accept any entries
®
for four minutes. If a key is pressed during
this time, all of the keys will flash RED and
the alarm beeps. A backup key can be used to
open the unit.

Quick Start Guide

Follow the quick start guide to get your safe up and running. If you have any questions or issues
please email support@vaulteksafe.com.
Quick Start Guide Battery Installation
LifePod is powered by a 9v Alkaline battery (not included).
®
Under normal use the battery can last up to one year.
Undo both side compression latches to open your LifePod
Locate the battery cover on the front wall and remove by
pressing on the outer tab (Fig B).
Pull out the 9v battery snap inside the battery compartment,
and connect an Alkaline 9V battery to the connector. Be sure to
snap the battery in the correct orientation (Fig C).
When the battery is snapped in you will hear a short welcome
tone and the keypad will light up.
Troubleshooting! If you snap the battery in and the keypad is flashing then your battery is likely
low. Replace the battery with a new 9v Alkaline battery. We recommend a brand name battery
like Duracell or Energizer.
Once you hear the tone and see the keypad light up, slide the battery into its compartment being
mindful to place the battery ribbon underneath the battery first (Fig D). This will make the battery
easier to remove when replacing.
Step 1
.
®
B
C
D
04 Vaultek ®