Warnings; Master Code Programming - Vaultek LifePod Instruction Manual

Warnings

To prevent damage to your LifePod ® or injury to yourself or to others, read the following safety
precautions before using this unit.
IMPORTANT Before locking your LifePod
® , always be sure the
side compression latches are latched closed first. This will
ensure the locking mechanism engages properly.
IMPORTANT Do not undo the compression latches until the
unit has been unlocked with the correct master code first.
Undoing the compression latches first may cause binding
on the lock mechanism and will not unlock.
LifePod ® is designed to protect against dust and splashes
with brief short immersions and will float when loaded with
weight up to 2lb.
LifePod can be submerged to 3 feet deep up to 30 minutes.
®
DISCLAIMERS:
Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or consequential, arising
out of the use of, or the inability to use, the Vaultek
The user shall determine the suitability of the Vaultek
all risk and liability whatsoever in connection therewith.
07 Vaultek ®
To ensure proper weather sealing:
ALWAYS check that the rubber gasket is free
of debris before closing the lid
ALWAYS check that the side compression
latches are fully engaged and closed
ALWAYS check that the front rubber cover is
closed tightly
DO NOT expose to extreme heat or cold.
Battery power may be affected. Acceptable
operation range is -14˚f to 120˚f.
DO NOT store loaded firearms in this unit.
® LifePod ® .
® LifePod ® before the intended use and user assumes

Master Code Programming

First time users should change the default code as soon as
possible to prevent unauthorized access when using the lock.
TIP: Code Requirements
• Your code can be a minimum of 4 digits, or as long as 8 digits.
Two keys can not be pressed simultaneously.
•
Programming a new code will overwrite your previous code.
•
IMPORTANT! The PROGRAM button will not function when
locked. Be sure the LifePod latch is in the unlocked position.
®
First open the unit and tap the lock pad to wake the unit up
(Fig J). When the keypad lights up, your LifePod
ready for programming.
While LifePod is awake press and hold the PROGRAM button
®
for 3 seconds (Fig K) until ALL keys (1-4) turn solid RED.
Enter your new code. Immediately press and hold the PROGRAM
button a second time for 3 seconds (Fig K) until ALL keys (1-4) turn solid RED.
Enter your new code a second time. Immediately press and hold the PROGRAM button a third
time for 3 seconds (Fig K). The status LED (Fig L) will flash GREEN and LifePod
confirm the code change is successful. If you make a mistake start over with step 1.
J
L
K
Tip! Water will affect the keypad
is awake and
®
performance. Wipe away excess
water and dry off the keypad
when opening for best results
and to prevent unwanted water
from entering the storage
compartment.
will beep to
®
08 Vaultek ®