Table of Contents
Advertisement
The controller has several modes that makes it possible to use
for manual and temperature-based control of the circulating
pumps in heating and cooling systems. In case of temperatu-
re-based control the connected pump switches on/off accor-
ding to set temperature and the switching sensitivity.
1. LOCATION OF THE DEVICE
It is recommended to install the pump controller in an
immersion sleeve installed in the heating / cooling pipe
or boiler on which the control is based, so that it is as
close as possible to a maximum of 1.5 m from the pump
to be controlled and the 230 V supply. Do not use a wet,
chemically aggressive or dusty environment.
- 3 -
Advertisement
Table of Contents
Need help?
Do you have a question about the WPR-100GE and is the answer not in the manual?
Questions and answers