Frigidaire FFAD2233W1 Use & Care Manual page 6

Operating I nstructions
Operating I nstructions
( continued)
5. The Filter reset light will illuminate after 250 hours of operation. At this time refer to the care and cleaning section
to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the Filter reset button
to extinguish the light.
6. The TI MER function enables you to either Delay Start or Delay Stop the unit in the choice from 0.5 hour to 24 hours.
I f the unit is running, then selecting Timer will turn the unit off in the hours that will be set (Delay Stop). I f the unit is
off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start).
TI MER setting: First press TI MER button, then adjust timer setting, by tapping or holding the
change the delay timer at 0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The
control will count down the time remaining (8,7.5,7, etc.) until the unit either starts or stops. For the Delay Start, the
fan speed and humidity maintained will be the same as previous setting. After TI MER setting finishes, pressing TI MER
button again at any time will stop the TI MER function. The Delay Start/ Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated.
NOTE:
1. Before entering TI MER setting, make sure power is being supplied to the unit.
2. Before entering TI MER setting, make sure pressing HUMI DI TY
7. To shut the unit down, press the ON/ OFF button.
Note: After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.
2019 Electrolux Home Products, I nc.
6
or button sets one desired room humidity first.
or button to
All rights reserved.