Epson UB-R05 Technical Reference Manual page 21

3
Activate Wireless Network Connection on the computer used to configure the
settings, and select [EPSON_Printer] as the connection device on the screen that
appears.
If the window to enter a pass phrase appears, enter "12345678".
Default settings on printer are the following values.
Network mode
SSID
Pass phrase
IP Address
An example of Connection Screen
 For the setting method for the computer for setting, see the manual for your computer.
 By factory default, the printer is set to an IP address that is assigned by the DHCP server. If multiple IP
addresses are in conflict on the same network, you will be unable to perform the setup procedure.
Therefore, make sure there is no conflict between IP addresses that are assigned by the DHCP server.
If there is no DHCP server, a fixed IP address (192.168.192.168) will be set about 1 minute after the
power is turned on. Note that these processes are executed after connection by wired or wireless LAN
is established.
 You can issue a ping command to check if the printer has been connected successfully.
(E.g.) ping 192.168.192.168
(when 192.168.192.168 is indicated on the status sheet)
4
When connecting to the printer is complete, setup the network by using the
EpsonNet Config or EpsonNet Config (Web version).
For details about each of these methods to configure the network settings, see the information at
the following links.
"Set up using EpsonNet Config" on page 22
"Set up using EpsonNet Config (Web version)" on page 23
SimpleAP mode
EPSON_Printer
12345678
192.168.192.168
Chapter 2 Setup
21