Gigabyte GA-586HX User Manual page 95

40
41 Initialize Floppy
Drive & Controller
42 Initialize Hard
Drive & Controller
43 Detect & Initialize
Serial/Parallel Ports
44 Reserved
45 Detect & Initialize
Math Coprocessor
46 Reserved
47 Reserved
48-4D Reserved
4E Manufacturing
POST Loop or
Display Messages
4F Security Check
50 Write CMOS
51 Pre-boot Enable
Display virus protest disable or enable.
Initialize floppy disk drive controller and any drives.
Initialize hard drive controller and any drives.
Initialize any serial and parallel ports (also game port).
Initialize math coprocessor.
Reboot if Manufacturing POST Loop pin is set.
Otherwise display any messages (i.e., any non-fatal errors
that were detected during POST) and enter Setup.
Ask password security (optional).
Write all CMOS values back to RAM and clear screen.
Enable parity checker.
Enable NMI, Enable cache before boot.
B-5
Appendix B: Post Codes