ADVANCED Network Devices Headline Clock User Manual page 8

APPENDIX – RUGGEDIZED WALL MOUNTING INSTRUCTIONS
1. Remove screws from both sides of the device and carefully separate the stainless steel baffle from the backplate slightly.
Unplug the internal network cable from the coupler on the backplate and set baffle aside.
2. Plug an external network cable into the coupler on the outside of the backplate. If there is concern over line
performance, wrap network cable around ferrite once and clamp shut. Mount backplate to wall using appropriate
mounting hardware; see included full-size template.
3. Reconnect the internal network cable to the coupler on the backplate.
4. Re-insert stainless steel baffle into the backplate and re-install both screws into the left side of the device, and one into
the right side of the device.
5. Place safety tether in wood frame over the open hole on right side of the device. Place remaining screw through this
tether and secure to the side of the device. Slide wood frame over the clock and push flush to the front of the device.
Headline Clock User Guide
For additional support, visit
Copyright Advanced Network Devices 2015
www.anetdsupport.com v 0.6