Installation - ADVANCED Network Devices Headline Clock User Manual

INSTALLATION

1. Mount the Headline Clock backplate to a wall, if desired, using the included template. See Appendix for ruggedized wall
mounting instructions.
2. Cabling Method 1, PoE Switch: Connect the Headline Clock network port to a PoE port of your network switch/router
using the included cable. If you are not sure if your switch/router is PoE, you can install using Method 2 with the PoE
injector.
Cabling Method 2, PoE Injector: For a non-PoE switch/router, use the included PoE injector. Connect the Headline Clock
network port to the OUT port of the PoE injector using the included cable. Connect the second included cable between
the IN port of the PoE injector to a port on your network switch/router. Connect the PoE injector power cable to a
110VAC wall outlet.
Headline Clock User Guide
Cabling Method 1: Switch/router is PoE-capable
Cabling Method 2: Switch/router is not PoE-capable
For additional support, visit
Copyright Advanced Network Devices 2015
www.anetdsupport.com v 0.6