Replacing The Fuses; Drive System Maintenance; Inspecting The Tires - Toro Pro Force Debris Operator's Manual

Replacing the Fuses

Engine
A 15 A in-line fuse is incorporated into the engine wire
harness (Figure 29).
Figure 29
1. Fuse
Receiver
A fuse block is incorporated into the receiver wire
harness. It is located behind the receiver on the right
side of the control tower
Figure 30
1. Fuse
(Figure 30).
Drive System
Maintenance

Inspecting the Tires

Service Interval: Every 100 hours
Check the tire pressure frequently to ensure proper
inflation (241 kPa or 35 psi). If the tires are not inflated
to the correct pressure, the tires will wear prematurely.
Operating accidents can damage a tire or rim, so
inspect the tire condition after an accident.
The DOT tire information is located on the side of
each tire. This information gives load and speed
ratings. Replacement tires should have the same or
better ratings.
Figure 31 is an example of tire wear caused by under
inflation.
g030098
1. Example of tire wear caused by underinflation
Figure 32 is an example of tire wear caused by over
inflation.
g029821
1. Example of tire wear caused by overinflation
28
Figure 31
Figure 32
g010294
g010293