Frigidaire FEB702CESG Installation Instructions Manual

Built-In Electric Oven
Installation
Instructions
IMPORTANT – Save for local
electrical inspector's use!
The rating plate is located on the internal side of the oven left hand side trim, it is visible when door is open.
!
CAUTION – To avoid the risk of electrical shock, turn
off power to oven branch circuit.
1. Check your local electric code or National Electric
Code through your power company or secure the
services of a qualified electrician.
CAUTION – TO AVOID THE RISK OF FIRE:
!
If your household branch-circuit wiring is alumi-
num, you must use special connectors designed for
this purpose and listed by Underwriters Laborato-
ries. Be certain to follow the connector manufac-
turer's instructions carefully.
FIGURE 1
1 1/2" min.
28 1/8" min.
29 5/8" max.
24 1/4"
26 7/8"
1 3/4" min.
29 1/8"
1 3/4"
4 MOUNTING
SCREWS
NOTE: Allow at least 26 1/4" clearance for door depth
when it is open.
Maintain a minimum distance of 3" to a wall
located on the door hinge side of the wall oven.
2. Measure cabinet carefully to ensure adequate clear-
ance and proper fit. Do not install wall oven under
the counter top.
This oven requires a wall or cabinet opening of
28 1/8" high by 24 7/8" wide and 23 1/2" deep mini-
mum.
Install the oven at least 10" above the floor (refer to
figure 1).
27" min.
HOLE
FOR
CABLE
23 1/2" min. (depth)
24 7/8" min. (large)
25 5/32" max.
GROUNDED
ELECTRICAL
JUNCTION BOX
10" min.
72" CABLE
READ THESE INSTRUCTIONS
BEFORE INSTALLING THE OVEN.
3. Cut out cabinet to size specified on this sheet.
Construct support-floor or 2 x 4 rails, covered with
plywood or similar material. Check and level front
to rear and side to side on support floor or rails.
Make sure this support is rigidly mounted, as it sup-
ports the total weight of the unit (110 lbs). MAKE
SURE THAT JUNCTION BOX IS PROPERLY LOCATED
AS SHOWN IN DIAGRAM.
Leave the bottom of the cabinet partially opened to
permit free air circulation, otherwise water conden-
sation may appear inside the control panel when
operating the oven.
4. Remove all shipping and packing materials from
unit and the lower grill assembly packed with the
oven.
5. There is 1 1/2" height adjustment on these models.
(See Figure 2) With this adjustment and a 1/2" top
trim overhand, a unit can be installed in existing
opening 28 1/8" to 29 5/8" high.
3" max.
FIGURE 2
1
DOOR
OPENING
OVEN
BOTTOM
MAX.
EXTENSION
1 1/2"
318128601 (9806) Rev. D
EXTENSION
PANEL
MOUNTING
SCREWS
SIDE
OF OVEN
Printed in Canada