JVC DLA-X500RBE Service Manual page 20

4.4.3 DESTINATION WRITING
Instruments Scaler Service Software REPLACING
Test point
Adjustment menu
Preparation
Note :
Perform this operation during standby mode.
PROCEDURE
(1) Run Scaler Service Software.
(2) From the COM Port, select the [Connect to FP] and con-
nect PC and projector.
(3) Select the destination from the Location, and write the
destination.
1-20 (No.PA048<Rev.002>)
4.4.4 TRANSFERRING CMS DATA FROM DD SUB PWB
Instruments
COMPONENTS
Test point
PROCESSOR
Adjustment menu
PWB
Preparation
Note :
Perform the operation with the power ON.
Input the signal from external equipment.
PROCEDURE
(1) Run the VP Writer application program.
(2) Select a COM Port.
(3) Click "Write".
(4) CMS data is transferred from the DD SUB PWB.
VP Writer
<If OK>
<If NG>
REPLACING
COMPONENTS
PROCESSOR
PWB
OPTICAL
BLOCK