Advertisement
2.6
SERVICE MENU
The service menu contains items not ordinarily needed by the user. Use these as necessary during service.
2.6.1 ENTER
(1) No menu shown.
(2) Press the [ ] button.
(3) Within press the [ ] button.
(4) Within press the [ ] button.
(5) Within press the [ ] button.
(6) Within press the [OK] button to display the service menu.
NOTE:
When the Service Menu Screen is not displayed, go back to
the beginning. It is recommended that you press the buttons a
little earlier and steadily.
2.6.2 RELEASE
Press the [MENU] button to exit the menu indication.
2.6.4 SETTING ITEMS
Item
Soft Ver.
Model
Main
IF
CMS_F
CMS_M
DDM
DD
MEMC
SPI
Location
Pixel shift
Horiz. Red
Horiz. Blue
Vert. Red
Vert. Blue
Adjust Pattern
Lens Position Reset
Lens Slide Cover
[X700R, 900R, XC7880R]
3D L/R Picture
Factory Reset
1-10 (No.PA048<Rev.002>)
Adjustment range
Only the display
Only the display
Only the display
Only the display
Only the display
Only the display
Only the display
Only the display
Only the display
Only the display
-2 - 2
-2 - 2
-2 - 2
-2 - 2
-
-
On / Off
Standard / L/R Switch
-
2.6.3 BASIC OPERATION
Use the following buttons to operate the service menu.
(1) Choose the SETTING MENU with the [ ] or [ ] button.
(2) When the [ ] button is pressed after choosing the SET-
TING MENU, the cursor will shift to the SETTING / AD-
JUSTMENT ITEMS of each SETTING MENU.
(3) When the cursor is shifted, choose the SETTING / AD-
JUSTMENT ITEMS with the [ ] or [ ] button.
(4) Using the [ ] or [ ] button, change the setup values and
adjustment values, respectively.
(5) When the [EXIT] button is pressed, the cursor will return to
the SETTING MENU.
(6) When the [MENU] button is pressed, the SERVICE MENU
will go out of the screen.
NOTE:
The SERVICE MENU will go out of the screen automatically
after 10 seconds if you do not press the [MENU] button.
Initial value
-
Display of model name
-
Display of Main CPU software version
-
Display of IF FPGA version
-
Display of VP FPGA version
-
Display of CMS CPU version that is built in VP
FPGA
-
Display of DD CPU version
-
Display of DD FPGA version
-
Display of PA168 version
-
Display of configuration data that is written in
SPI-ROM
-
Display of destination
0
Adjust REGI (Pixel shift) of Horizontal Red
0
Adjust REGI (Pixel shift) of Horizontal blue
0
Adjust REGI (Pixel shift) of Vertical Red
0
Adjust REGI (Pixel shift) of Vertical Blue
Coror crosshatch
Select of the adjust pattern
-
-
On
Interlocking control of the lens slide cover
Standard
Phase setting of 3D signal
-
Resets all items supporting All Reset to factory
settings
Function
Hide quick links:
Advertisement
