E2S SONFL1H Series Instructions/Service Manual

INSTRUCTION & SERVICE MANUAL
SONFL1H Range - Alarm Horn & L.E.D Beacon
SONFL1H Combined Sounder & L.E.D Beacon
10 Selectable Tones & 2 Stages
High Output L.E.D Array
8 Flash Modes:
Steady On
Flashing - 1Hz, 1.5Hz, 2Hz
Double Strike, Triple Strike, Temporal, Blinking
CE, EAC Approved
UL / cULus Approved
IP Rating: Type 3R / 13, IP66
Beacon is General Signalling Approved for US & Canada
UL1638A & CSA22.2 - 205-17
Clear Lens Beacon is Private Mode Fire Approved
for US & Canada UL1638, CAN/ULC-S526
Model No. Nominal Voltage
SONFL1HDC012...[X]/[Y] 12V dc
SONFL1HDC024...[X]/[Y] 24V dc
SONFL1HAC115...[X]/[Y] 115V ac 50/60Hz
SONFL1HAC230...[X]/[Y] 230V ac 50/60Hz
*Current at nominal voltage on Tone 2
[X] Denotes Housing Colour: R = Red; G = Grey; W = White
[Y] Denotes Lens Colour: A = Amber; B = Blue; C = Clear; G = Green; M = Magenta; R = Red; Y = Yellow
5
0.5 1.5mm
Use suitable conduit or cable glands with
suitable IP or type rating
Attention: Installation must be carried out by an electrician in compliance with the latest codes and regulations.
Attention: L'installation doit être effectuée par un électricien conformément aux derniers codes et réglementations.
Achtung: Die Installation muss von einem Elektriker gemäß den neuesten Vorschriften und Bestimmungen durchgeführt wer
den.
Attenzione: L'installazione deve essere eseguita da un elettricista in conformità con i codici e le normative più recenti.
Atención: La instalación debe ser realizada por un electricista de acuerdo con los últimos códigos y regulaciones.
Atenção: A instalação deve ser realizada por um eletricista de acordo com os códigos e regulamentos mais recentes.
Внимание: установка должна выполняться электриком в соответствии с последними нормами и правилами.
Attention: Disconnect from power source before installation or service to prevent electric shock
Attention: Débranchez-le de la source d'alimentation avant l'installation ou l'entretien pour éviter tout choc électrique.
Achtung: Vor Installation oder Wartung von der Stromquelle trennen, um einen Stromschlag zu vermeiden.
Attenzione: scollegare dall'alimentazione prima dell'installazione o dell'assistenza per evitare scosse elettriche.
Atención: desconéctelo de la fuente de alimentación antes de la instalación o el servicio para evitar descargas eléctricas.
Atenção: Desconecte da fonte de alimentação antes da instalação ou serviço para evitar choque elétrico
No liability is accepted for any consequences of the use of this document. The technical specification of this unit is subject to change without notice due to our policy of continual
product development. All dimensions/weights are approximate. This unit is sold subject to our standard conditions of sale, a copy of which is available on request.
E2S Warning Signals
Impress House, Mansell Road, Acton, London W3 7QH
Dimensions: 172 x 86 x 83mm
Cable Entry: 2-off M20 x 1.5mm
Temp: -40°C to +55°C
Unit weight: 0.46Kg
SONFL1H
Sound Pressure Level dB(A)
Horn Nom. Beacon Nom.
Voltage Range
Current Current
Max
10-14V dc 25mA* 79.5mA
20-28V dc 25mA* 87mA
100.0 @ 1m
91.0 @ 3m
+/- 10% 27mA 34mA
+/- 10% 39mA 19mA
Terminal Connections
sales@e2s.com e2s.com
See D242-06-601 - Schematic Wiring
AC Circuit
Nominal
99.0 @ 1m
90.0 @ 3m
0.4Nm
Page 1 of 2
DC Circuit
DC
AC
D242-00-601-IS_Issue_2 - 03/06/2021