Transporting Lithium Batteries; Maintenance; Clearing A Blockage - Ryobi R18EZBLW Manual

Table of Contents

Advertisement

BLOWER SAFETY WARNINGS
Wear a face filter mask in dusty conditions
to reduce the risk of injury associated with
the inhalation of dust.
Do not use the product near open windows.
Use the full blower nozzle extension so that
the air stream can work close to the ground
and perform effectively.
Do not point the blower nozzle in the
direction of people or pets.
Never place objects inside the blower tubes.
Do not place the product on top of or near
loose debris. Debris can be sucked into the
intake vent, resulting in possible damage to
the product.
ADDITIONAL BATTERY SAFETY
WARNINGS
To reduce the risk of fire, personal injury, and
product damage due to a short circuit, never
immerse the tool, battery pack or charger in
fluid or allow fluid to flow inside them. Corrosive
or conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach-
containing products, etc., can cause a short
circuit.
TRANSPORTATION AND STORAGE
Turn off the product, remove the battery
pack, and allow it to cool down before
storing or transporting.
Remove all foreign materials from the
product. Store the product in a cool, dry, and
well-ventilated place that is inaccessible
to children. Keep the product away from
corrosive agents, such as garden chemicals
and de-icing salts. Do not store the product
outdoors.
For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.

TRANSPORTING LITHIUM BATTERIES

Transport the battery pack in accordance with
local and national provisions and regulations.
Follow all special requirements on packaging
and labelling when transporting batteries by a
third party. Ensure that no batteries can come
in contact with other batteries or conductive
materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
battery packs that are cracked or leaking.
4
Original Instructions
Check with the forwarding company for further
advice.

MAINTENANCE

Use only original manufacturer's replacement
parts, accessories, and attachments. Failure
to do so can cause possible injury, can
contribute to poor performance, and may void
the warranty.
Servicing
requires
knowledge and should be performed only by a
qualified service technician. Have the product
serviced by an authorised service centre only.
You may make adjustments or repairs that
are described in this manual. For other
repairs, contact an authorised service
centre.
After each use, clean the product with a
soft, dry cloth.
Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure that
the product is in safe working condition. Any
part that is damaged should be properly
repaired or replaced by an authorised
service centre.
Bring the product to an authorised service
centre to replace damaged or unreadable
labels.

CLEARING A BLOCKAGE

To reduce the risk of injury associated with
contacting moving parts, always turn off
the product, remove the battery pack, and
make sure that all moving parts have come
to a complete stop.
Remove the blower tubes to inspect for
blockage. Clear the tubes if required.
Reinstall the blower tubes before starting
the product.
SYMBOLS ON THE PRODUCT
Read
instructions before operating
the product. Follow all warnings
and safety instructions.
Do not expose the product to
rain or damp conditions.
Wear a mask.
Wear eye and ear protection.
Never operate the product
closer
10m
overhead power lines.
extreme
care
and
and
understand
all
than
10
m
from

Advertisement

Table of Contents
loading

This manual is also suitable for:

R18ezblwa

Table of Contents