JUKI Q141 Instruction Manual & Parts List
JUKI Q141 Instruction Manual & Parts List

JUKI Q141 Instruction Manual & Parts List

Tape guide

Advertisement

テープ案内
tape Guide
Q141
取扱説明書 / パーツリスト
INstructIoN MaNual / Parts lIst
安全に使用していただくために使用前に、必ずこの取扱説明書をお読みください。
また、いつでもすぐに読めるように、この取扱説明書を保管してください。
本取扱説明書は、Q141 についての説明書です。本製品を MO-3000, MO-6000 シリー
注意
ズに取り付けて使用される際は、 事前に MO-3000, MO-6000 シリーズの取扱説明書の 「安
全についての注意事項」を読み、十分理解の上でご使用ください。なお、Q141 を強調す
るため、MO-3000, MO-6000 シリーズのイラストは簡略化されています。従って、安全
装置のイラストも一部省略しております。
read safety instructions carefully and understand them before using.
retain this Instruction Manual for future reference.
cautIoN :
this Instruction Manual is intended for the Q141. read and fully understand the
instructions given under "IMPortaNt saFEtY INstructIoNs" in the Instruction
Manual the Mo-3000, Mo-6000 series before putting the machine into service when this
device is installed to the Mo-3000, Mo-6000 series.
In addition, to emphasize the Q141, some illustrations of the Mo-3000, Mo-6000 series
are simplified. Also, illustrations of the safety devices are partially omitted.
No.05
29114717

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Q141 and is the answer not in the manual?

Questions and answers

Summary of Contents for JUKI Q141

  • Page 1 Instruction Manual for future reference. cautIoN : this Instruction Manual is intended for the Q141. read and fully understand the instructions given under “IMPortaNt saFEtY INstructIoNs” in the Instruction Manual the Mo-3000, Mo-6000 series before putting the machine into service when this device is installed to the Mo-3000, Mo-6000 series.
  • Page 2 1. 仕 様 / sPEcIFIcatIoNs 適 用 機 種:MO-3000, MO-6000 シリーズ全機種 最高回転数:7,000 rpm Applicable models : All models of MO-3000, MO-6000 series Max.sewing speed : 7,000 rpm 2. 装置の取り付け / INstallatIoN 1) 目保護カバー止めねじ❶ (1 個 ) を取り外します。 2) テープ案内総組❷を目保護カバー ❺の上からテープ案内取り付けね じ❸とテープ案内取り付け座金❹ で取り付けます。 ( 図ー 1) ❶ from the eye 1) Remove screw ❶...
  • Page 3 3. 調整 / aDJustMENt テープ案内の位置 テープ Position of the tape guide tape テープ案内❶の位置は、押えのテープガイ ド部にまっすぐ入るようテープ案内取り付 けねじ❷をゆるめて左右方向を調整してく ださい。 ( 図ー 2) ❶ Loosen attaching screw ❷ , and adjust the lateral position of tape guide ❶ so that the tape to be sewn is fed straight into the tape guiding section of the presser foot. (Fig. 2) ❷...
  • Page 4 TOKYO, 206-8551, JAPAN PHONE : (81)42-357-2371 FAX : (81)42-357-2274 http://www.juki.com この製品の使い方について不明な点がありましたらお求めの販売店又は当社営業所にお問い合わせください。 ※この取扱説明書は仕様改良のため予告なく変更する事があります。 Copyright © 1998-2011 JUKI CORPORATION • 本書の内容を無断で転載、複写することを Please do not hesitate to contact our distributors or agents in your area for further information when necessary. 禁止します。 * the description covered in this instruction manual is subject to change for improvement of the commodity without notice.

Table of Contents