Boutside Back Exhaust; Outside Back Exhaust; Remove Blower Plate - Frigidaire FFMV154CLS Installation Instructions Manual

OUTSIDE BACK EXHAUST

B
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Remove Blower Plate
B3. Attach Mounting Plate to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Microwave Oven
IMPORTANT NOTES:
•
Make sure the screws for the
blower motor and blower plate
are securely tightened when
they are reinstalled. This will
help to prevent excessive
vibration.
•
Make sure the motor wiring has
been properly routed and secured,
and that the wires are not pinched.
PREPARING THE REAR WALL
B1.
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
•
Read the instructions on the REAR
WALL TEMPLATE.
•
Tape it to the rear wall, lining up with the
holes previously drilled for holes A and B
in the wall plate.
•
Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
Installation Instructions
16
(Horizontal Duct)

REMOVE BLOWER PLATE

B2.
Remove and save the screw that holds the blower
plate to the microwave. Lift off the blower plate.
Blower Plate
Back of
Microwave