Advertisement
A
B
Illustration 2
ELECTRICAL OUTLET LOCATION
Outlet should NOT be in the shaded area as indicated on
Illustration 2
NOTE 1:
If the Depth (C) dimension is greater than 21" (53.3 cm),
the outlet location may be in any area on the rear wall.
NOTE 2:
The floor of the opening should be constructed of ply-
wood strong enough to support the weight of the oven
and floor load (approximately 100 pounds). The floor
should be level for proper operation of the oven. Be sure
to check the local building code as it may require that the
opening be enclosed with side, ceiling and rear partition.
The proper functioning of the oven does not require the
enclosure.
Installation Instructions
6"
(15.2 cm)
C
Flanges
Screw A
Exhaust Duct
Assembly
Illustration 3
EXHAUST DUCT ASSEMBLY
1. Place the Exhaust Duct in the opening. When the
Exhaust Duct Assembly is in the opening correctly,
the flanges will be tightly against the lower edge of
the opening. See Illustration 3.
2. Secure the Exhaust Duct Assembly with the two
screws A.
IMPORTANT: Secure screws in outer hole.
3
Screw A
Advertisement
