Table of Contents
Advertisement
Quick Links
assembly instructions
RC040 - cube ReFrame®
2
Insert corner bracket into frame length (ensuring the bracket is set in as far as possible)
3
Repeat step 2 on the remaining 3 corners of the bottom
frame lengths
www.afibranding.com.au
4
|
1300 652 514
|
33 Lakewood Blvd, Carrum Downs, Vic, 3201
1
1
Lay out the ReFrame®
components on a flat
surface and ensure you have
everything required before
you start the assembly.
CHECKLIST
8x
12x
24x
1x
Bridge the two parallel bottom frame lengths to make a
square base
Corner Brackets
ReFrame® Lengths
Screws
Drill
Advertisement
Table of Contents
Related Manuals for AFi ReFrame cube RC040
Summary of Contents for AFi ReFrame cube RC040
- Page 1 assembly instructions RC040 - cube ReFrame® Lay out the ReFrame® components on a flat surface and ensure you have everything required before you start the assembly. CHECKLIST Corner Brackets ReFrame® Lengths Screws Drill Insert corner bracket into frame length (ensuring the bracket is set in as far as possible) Repeat step 2 on the remaining 3 corners of the bottom Bridge the two parallel bottom frame lengths to make a frame lengths...
- Page 2 ‘standard’ Cube type ReFrame®. If your Reframe® is oversize, has additional components such as joiners (not shown on this fact sheet), accessories, or has bends/curves and you are unsure how to proceed with assembly, please contact the team at AFI Branding on 1300 652 514 and we will guide you through the assembly process.
Need help?
Do you have a question about the ReFrame cube RC040 and is the answer not in the manual?
Questions and answers