Adjusting The Discharge-Chute Latch; Replacing The Drive Belts; Storage; Storing The Machine - Toro Power Max e26 Operator's Manual

8. Move the speed-selector lever forward and
rearward a few times.
9. Install the back cover and return the machine to
the operating position.
Adjusting the
Discharge-Chute Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge-chute latch.
1. Loosen the clamp fastener on the chute-support
plate until the cable is free.
1. Cable conduit
2. Cable clamp
2. Remove any slack in the cable by pulling the
cable conduit rearward.
3. Tighten the clamp fastener while holding the
cable in place.

Replacing the Drive Belts

If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged,
have an Authorized Service Dealer replace the belt.
Figure 36
3. Clamp fastener

Storage

Storing the Machine

Important:
Store the machine, battery pack, and
charger only in temperatures that are within the
appropriate range; refer to
15).
Important:
If you are storing the battery pack
for the off-season, charge it until 2 or 3 LED
indicators turn green on the battery. Do not store
a fully charged or fully depleted battery. When
you are ready to use the machine again, charge
the battery pack until the left indicator light turns
green on the charger or all 4 LED indicators turn
green on the battery.
•
Disconnect the product from the power supply
(i.e., remove the plug from the power supply or
the battery pack), remove the key, and check for
damage after use.
•
Clean all foreign material from the product.
•
Do not store the tool with the battery pack installed.
•
When not in use, store the machine, battery
pack, key, and battery charger out of the reach of
children.
•
Keep the machine, battery pack, key, and battery
charger away from corrosive agents, such as
garden chemicals and de-icing salts.
•
To reduce the risk of serious personal injury, do
not store the battery pack outside or in vehicles.
g019021
•
Touch up chipped surfaces with paint available
from an Authorized Service Dealer. Sand affected
areas before painting, and use a rust preventative
to prevent the metal parts from rusting.
•
Tighten all loose screws, bolts, and locknuts.
Repair or replace any damaged parts.
•
Store the machine, battery pack, key, and battery
charger in an enclosed clean, dry area.
Preparing the Battery Pack for
Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
27
Specifications (page