Universal Water Controller (Mc-601Q) Operation - Rinnai Infinity 26 Touch Operation & Installation Manual

UNIVERSAL WATER CONTROLLER (MC-601Q) OPERATION

PREHEAT INDICATOR
Indicates that the Smartstart preheater (when fitted) is
activated.
PREHEAT BUTTON
Used to start and stop the Smartstart preheat unit (when
fitted), See Smartstart Operation on page 11.
CONTROLLER PRIORITY INDICATOR
Indicates if this water controller is in control of water
delivery temperature.
PRIORITY TRANSFER BUTTON
Used to transfer control priority between water
controllers. The water controller with priority has
command of the hot water delivery temperature.
Turning On
Adjusting Temperature
or
NOTE
all hot water taps have been closed.
Temperatures higher than 50ºC MUST NOT be able to be selected on controllers installed in
bathrooms, ensuites or toilets. This is to help reduce the risk of burns from hot water. If this is not
the case, the controllers have been incorrectly installed. CONTACT YOUR INSTALLER.
The 'beep' sound can be muted by pressing the
3 seconds. To cancel sound muting, simply repeat the process.
Always check outlet water temperature before use. The parent / carer MUST check the temperature
before placing dependants in contact with hot water, see "Warning About Hot Water" on page 4.
CAUTION
Transferring Priority
Rinnai
WATER HEATER 'IN USE' INDICATOR
Indicates that a water heater is delivering hot water.
Indicates the temperature selected.
Error messages flash in event of a fault.
TEMPERATURE CONTROL BUTTONS
Used to select water temperature.
WATER HEATER ON INDICATOR
Indicates that the hot water heater is on.
Used to switch the water heater on and off.
or
and buttons simultaneously for more than
10
DIGITAL MONITOR
ON/OFF BUTTON
ON! ON!
COLD COLD
HOT HOT
HW_CF OIM