Polaris 4500 PRO HD Manual page 5

6. INSTALL RUBBER STOP MAGNET AND WINCH
HOOK.
a. Shift winch into "neutral" and pull rope/cable
6-12" (15-30 cm) out through fairlead. Thread
rope through rubber stop magnet
sure that the tapered edge with the embossed
"Polaris" logo is facing forward as shown.
s
Install hook to the rope by inserting clevis
pin through hook and rope and securing with a
cotter pin.
HINT: Attach a plastic cable tie to the end of
the rope and feed the cable tie through the
rubber stop. Use a little wax or other mild
lubricant on the rubber stop and pull the rope
through the rubber stop using the plastic cable
tie.
7. INSTALL WIRELESS RECEIVER.
a. Use supplied cable ties to secure the wireless
remote receiver to the chassis in the location
shown below with power/control wires facing
towards the center of the vehicle.
Wire routing and connections will be completed
in step 9 once all components have been
mounted.
2&
a
, making
Instr 9929140 Rev 01 2018-08
8. INSTALL DASH SWITCH.
a. Remove dash switch panel
out along the edges. Once dash panel is out,
remove switch plug
b. Install dash switch
pressing the switch firmly into position until it is
fully seated as shown.
Page 5 of 17
A
by gently pulling
B
.
q
into the mounting hole by