IHP DUALBURNER24NE Installation And Operation Instructions Manual

IHP DUALBURNER24NE Installation And Operation Instructions Manual

Vented gas log and burner set
Hide thumbs Also See for DUALBURNER24NE:

Advertisement

Quick Links

P/N 901174-00 REV. NC 07/2021
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
WARNING: This appliance is for installation only in a solid-fuel burning masonry or UL127 factory-
built fireplace, constructed of noncombustible material, and connected to a working flue. (See page 6 for
minimum flue opening.)
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
- Installation and service must be performed by a qualified installer, service agency or the gas supplier.
This appliance may be installed in an aftermarket permanently located, manufactured (mobile) home, where
not prohibited by local codes. This appliance is only for use with the type of gas indicated on the rating plate.
This appliance is not convertible for use with other gases.
* Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer
Installation and Operation Instructions
Vented Gas Log and Burner Set
PFS
®
C
US
Report No. F21-713
For use with log sets
ASHTONWHITEBIRCH24 OZARKCHARREDOAK24
ASHTONWHITEBIRCH24 OZARKCHARREDOAK30
ASHTONWHITEBIRCH36 OZARKCHARREDOAK36
Battery Electronic Models
DUALBURNER24NE
DUALBURNER24PE
DUALBURNER30NE
DUALBURNER30PE
DUALBURNER36NE
DUALBURNER36PE
SMOKYWEATHEREDOAK24
SMOKYWEATHEREDOAK30
SMOKYWEATHEREDOAK36

Advertisement

Table of Contents
loading

Summary of Contents for IHP DUALBURNER24NE

  • Page 1 Installation and Operation Instructions Vented Gas Log and Burner Set Battery Electronic Models P/N 901174-00 REV. NC 07/2021 ® DUALBURNER24NE DUALBURNER24PE Report No. F21-713 DUALBURNER30NE DUALBURNER30PE DUALBURNER36NE DUALBURNER36PE For use with log sets ASHTONWHITEBIRCH24 OZARKCHARREDOAK24 SMOKYWEATHEREDOAK24 ASHTONWHITEBIRCH24 OZARKCHARREDOAK30 SMOKYWEATHEREDOAK30 ASHTONWHITEBIRCH36 OZARKCHARREDOAK36 SMOKYWEATHEREDOAK36 INSTALLER: Leave this manual with the appliance.
  • Page 2: Table Of Contents

    More frequent cleaning may be required as necessary. It is imperative that the control compart- Appliance base assembly becomes very hot when ment, burners, and circulating air passageways of the running appliance. appliance are kept clean. 901174-00 NC ihp.us.com...
  • Page 3 1. WARNING: This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases. 2� Do not place propane/LP supply tank(s) inside any structure� Locate propane/LP supply tank(s) outdoors (propane/LP units only)� 901174-00 NC ihp.us.com...
  • Page 4: Local Codes

    UL 127 listed wood burning fireplace� ELECTRONIC IGNITION SYSTEM This appliance has an electronic igniter to light appliance fuel supply� ASHTON WHITE BIRCH 24" OZARK CHARRED OAK 24" 901174-00 NC ihp.us.com...
  • Page 5: Installation

    NOTE: When installing your gas logs into a manufactured firebox, Damper Damper follow firebox manufacturer's instructions for minimum clearances to combustible materials� Masonry Fireplace Manufactured Fireplace Figure A - Attaching Damper Clamp 901174-00 NC ihp.us.com...
  • Page 6 26.5 31.2 35.9 40.3 44.5 48.6 52.7 56.6 * Height is from hearth to top of chimney and the minimum height is 10 feet. ** Chart shows mainimum opening (sq. in.) for the given height and input 901174-00 NC ihp.us.com...
  • Page 7 When an appliance is for connection to a fixed piping system, the installation must conform with local codes, or in the absence of local codes with the National Fuel Gas Code, ANSI Z223.1 • NFPA 54; National Fuel Gas Code. 901174-00 NC ihp.us.com...
  • Page 8 6� Light appliance (see Remote Lighting, Page 11)� Check all other a leak. Apply a noncorrosive leak detection fluid to internal joints for leaks� all joints. Bubbles forming show a leak. Correct all 7� Turn off appliance (see Shutting Down, Page 11). leaks at once. 901174-00 NC ihp.us.com...
  • Page 9 Figure D - Equipment Shutoff Valve Propane/LP Equipment Supply Tank Shutoff Valve Control Valve Location Figure E - Checking Gas Joints (Propane/LP Only) Equipment Shutoff Valve Gas Meter Control Valve Location Figure F - Checking Gas Joints (Natural Gas Only) 901174-00 NC ihp.us.com...
  • Page 10 Please refer to specific Log Placement Guides placed inside each Log Set� DUALBURNER24/30/36-NE/PE BURNER SYSTEM LOG COMPATIBILITY CHART Burner System Model Log Sets For Use With This Burner System ASHTONWHITEBIRCH24 DUALBURNER24NE OZARKCHARREDOAK24 DUALBURNER24PE SMOKYWEATHEREDOAK24 ASHTONWHITEBIRCH30 DUALBURNER30NE OZARKCHARREDOAK30 DUALBURNER30PE...
  • Page 11: Operation

    (within 5 seconds of pilot lighting), press the OFF button on the remote transmitter and/or slide the switch to the OFF IF YOU SMELL GAS, SEE STEP B ABOVE. SHUTTING DOWN For remote shut down, PILOT APPEARANCE 901174-00 NC ihp.us.com...
  • Page 12: Inspecting Burners

    Natural Gas Propane/Lp Gas Models High Rate High Rate WARNING: Failure to keep the primary air opening(s) of the burner(s) clean may result in sooting DUALBURNER24NE 55,000 and property damage. DUALBURNER24PE 50,000 BURNER INJECTOR HOLDER AIR INLET HOLE DUALBURNER30NE 70,000...
  • Page 13: Wiring Diagram

    WIRING DIAGRAM INSTALLATION IGNITION MODULE PILOT ASSEMBLY (THROUGH GAS LINE CONDUIT) ORANGE (I) (THROUGH INDEPENDENT CONDUIT) BLACK(S) WIRE HARNESS BLACK PILOT WIRE PILOT GAS LINE ORANGE (TH/TP) BLACK (TP) BLACK GREEN (TH) GAS VALVE BATTERY HOLDER REMOTE RECEIVER 901174-00 NC ihp.us.com...
  • Page 14: Transmitter

    LEARN buttoni nside the hole� When you release the LEARN button the receiver will emit an audible “beep”� After the receiver emits the beep press the transmitter ON button and release� The receiver will emit several beeps indicating that the transmitter’s code has been accepted into the receiver� 901174-00 NC ihp.us.com...
  • Page 15: Troubleshooting

    2� Control valve or gas control defective 2� Replace control valve or gas control Gas odor during combustion 1� Gas leak� See Warning: If you smell 1� Locate and correct all leaks (see Checking Gas gas statement above Connections, Page 8) 901174-00 NC ihp.us.com...
  • Page 16 This the burner is normal when the appliance is installed outdoors in windy conditions 4� Wire connection loose or wire broken 4� Check wiring connections (see wiring diagram, Page 13). Replace wire harness if necessary 901174-00 NC ihp.us.com...
  • Page 17: Replacement Parts

    • burners will have delayed ignition Normally, all parts should be ordered through your IHP distributor • appliance will not produce specified heat or dealer� Parts will be shipped at prevailing prices at time of order�...
  • Page 18: Parts

    PARTS MODELS: DUALBURNER24NE, DUALBURNER24PE, DUALBURNER30NE, DUALBURNER30PE, DUALBURNER36NE AND DUALBURNER30PE. WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifi- cally approved with this heater may result in property damage or personal injury.
  • Page 19 This list contains replaceable parts used in your appliance� When ordering parts, follow the instructions listed under Replacement Parts on Page 17 of this manual� WARNING: Contact an IHP dealer to obtain any of these parts. Never use substitute materials not ap- proved by IHP. Use of non-approved parts can result in poor performance and safety hazards.
  • Page 20: Warranty

    In order for any claim under this warranty to be valid, you must contact the IHP dealer/distributor from which you purchased the product. If you cannot locate the dealer/ distributor, then you must notify IHP in writing. IHP must be notified of the claimed defect in w riting within 90 days of the date of failure. Notices should be directed to the IHP Warranty Department at 1769 East Lawrence Street;...
  • Page 21 Type of gas appliance uses Dealer name Innovative Hearth Products (IHP) reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information.

Table of Contents