Safety And Warning Information - Campbell Hausfeld PW2575 Product Manual

Campbell hausfeld gasoline powered pressure washer product manual
Table of Contents

Advertisement

Lavadoras a Presión
Operación de alta presión
1. Asegúrese de que la lavadora a presión esté funcio-
nando.
2. Gire el indicador de la tapa
hacia la posición de encendido
"ON" para aplicar el jabón
(Figura 4).
3. Tire hacia atrás la boquilla
Figura 4
negra para asegurarse que la
lanza esté en el modo de alta
PRESIÓN ALTA
presión (Figura 5).
Figura 5
8
7
10
12
9
5
6
Para ordenar repuestos,
sírvase llamar al 1-800-330-0712
(En los Estados Unidos,
o llame a su distribuidor local)
Sírvase proporcionar la siguiente información:
-Número de modelo
-Número de serie (si lo hubiera)
-Descripción y número del repuesto, según se
indica en la lista de repuestos.
Puede escribirnos a:
Campbell Hausfeld
Attn: Customer Service
100 Production Drive
Harrison, OH 45030
4. Gire la cubierta de la boquilla
para ajustar el patrón de rocia-
do de chorro a rociado amplio
(Figura 6).
5. Antes de enjuagar, mueva el
indicador de la tapa hacia la posición
de "OFF" (apagado) para cerrar el sum-
inistro de jabón (Figura 7).
6. Proporción de agua/jabón: 12 a 1
1
3
4
No. de
Número del
Descripción
Ref.
repuesto
L
1
Lanza de inyección
I
2
Tanque de la lanza
I
3
Anillo en O
I
4
Tubo de succión
I
5
Tapa interior
I
6
Tapa exterior
7
Tornillo
MJ106100AV
8
Anillo en O
MJ106511AV
9
Tubo de conexión
PM268450AV
L
10
Conj. de válv. de retención
I
11
Pesa del tubo de succión
12
Grapa
PM342410AV
Juegos de Repuesto
L
Juego de la Lanza
PM268500AV
I
Juego del tanque
PM268680SJ
30 Sp
Pressure Washers

Safety and Warning Information

Safety Guidelines
This manual contains information that
is very important to know and
understand. This information is
provided for SAFETY and to PREVENT
Figura 6
EQUIPMENT PROBLEMS. To help
recognize this information, observe the
following symbols.
Danger indicates an
imminently
hazardous situation which, if not
avoided, WILL result in death or serious
injury.
Figura 7
Warning indicates a
potentially
hazardous situation which, if not
avoided, COULD result in death or
serious injury.
Caution indicates a
potentially
hazardous situation which, if not
avoided, MAY result in minor or
moderate injury.
2
Notice indicates
important
information, that if not followed, may
cause damage to equipment.
NOTE: Information that requires special
attention.
Important Safety Instructions
SAVE THESE INSTRUCTIONS
When using this product, basic
11
precautions should always be followed,
including the following:
1. Read all instructions before using the
product.
2. To reduce the risk of injury, close
supervision is necessary when the
Ctd.
product is used near children.
3. Follow all safety codes as well as the
1
Occupational Safety and Health Act
1
(OSHA).
1
1
4. Ensure safety devices are operating
1
properly before each use. DO NOT
1
remove or modify any part of the
, I
1
gun or unit.
, I
3
5. Know how to stop this product and
, I
1
bleed pressure quickly. Be thoroughly
1
familiar with the controls.
1
6. Stay alert – watch what you are
, I
1
doing.
7. Do not operate the product when
1
fatigued or under the influence of
1
alcohol or drugs.
while the system is pressurized. To
8. Keep operation area clear of all
depressurize machine, turn power
persons.
and water supply off, then press
9. Do not overreach or stand on
the gun trigger 2-3 times.
unstable support. Keep good footing
Never permanently engage the
and balance at all times.
trigger mechanism on the gun.
10. Follow the maintenance instructions
Never operate the machine without
specified in the manual.
all components properly connected
Risk of injection
to the machine (handle, gun/wand
or severe injury.
assembly, nozzle, etc.).
Keep clear of nozzle. Do not discharge
streams at persons. This product is to
be used only by trained operators.
Always remove lance from gun before
ALWAYS turn water supply "ON"
cleaning debris from tip.
before turning pressure washer
Keep clear of nozzle. NEVER direct
"ON." Running pump dry causes
high pressure spray at a person,
serious damage.
animal, or yourself.
Do not operate the pressure washer
Always wear safety glasses or
with the inlet water screen
goggles and protective equipment
removed. Keep screen clear of
(hearing protection, gloves, rubber
debris and sediment.
boots, protective clothing) when
operating or performing
NEVER operate pressure washer
maintenance.
with broken or missing parts. Check
Never put hand or fingers over the
equipment regularly and repair or
spray tip while operating the unit.
replace worn or damaged parts
Never try to stop or deflect leaks
immediately.
with any body part.
Use only the nozzle supplied with
Always engage the trigger safety
this machine.
latch in the safe position when
Never leave the wand unattended
spraying is stopped even if only for
while the machine is running.
a few moments.
Never tamper with the engine
Always follow detergent
governor or attempt to alter
manufacturer's label
factory settings. Altering factory
recommendations for proper use of
settings could damage the unit and
detergents. Always protect eyes,
will void the warranty.
skin, and respiratory system from
Always hold gun and wand firmly
detergent use.
Do not use pres-
when starting and operating the
sure that exceeds
machine.
the operating pressure of any of the
NEVER allow the unit to run with
parts (hoses, fittings, etc.) in the
pressurized system. Ensure all
the trigger released (off) for more
equipment and accessories are rated to
than one minute. Resulting heat
withstand the maximum working
buildup will damage the pump.
pressure of the unit.
NEVER store the pressure washer
Explosion
hazard.
outdoors or where it could freeze.
Freezing temperatures can seriously
NEVER spray flammable liquids or
use pressure washer in areas
damage the pump.
containing combustible dust,
Release the trigger when changing
liquids, or vapors.
from high to low pressure modes.
Never operate this machine in a
Failure to do so could result in
closed building or in or near an
damage to the nozzle.
explosive environment.
Do not remove fuel tank cap or fill
fuel tank while engine is hot or
Bursting hoses may cause injury.
running (allow engine to cool two
Examine hoses regularly and replace if
minutes before refueling). Always
damaged. Do not attempt to mend a
damaged hose.
fill the tank slowly.
Never disconnect the high pressure
discharge hose from the machine
3
Equipment
damage.
Keep hose away
from sharp objects.
www.chpower.com

Advertisement

Table of Contents
loading

Table of Contents

Save Article as PDF