Waves BSS DPR-402 User Manual page 12

NOISE
Controls the amount of modeled noise and hum added to the processed signal.
Range: Off to 100
Default: Off
Reset: Off
MONITOR (Stereo Component Only)
Selects the source of the monitor output.

Left – Left output is sent to both sides (in MS Mode this monitors the mid).

Mono – Left and Right outputs are summed to mono and trimmed down by 6 dB.

Stereo – Stereo mode.

Right – Right output is sent to both sides (in MS Mode, this monitors the sides).
Default: Stereo
Reset: Stereo
STEREO MODE (Stereo Component Only)
Selects the stereo processing mode. There are three modes:

Stereo – All controls are in Link mode. When you set a control on one side (L or R), the
other side changes by the same value. Any difference in the settings between sides
(created using the Duo or MS mode) are preserved when you move back to Stereo
mode.

Duo – Controls can be set independently for each side, L and R.

MS – Applies an MS encoding matrix to the input of the plugin, allowing you to
separately compress and level the Mid (sum) and Sides (difference) signals. In this
mode, the letters M and S will be added at the header of the channels (M at the top left,
S at the top right). In MS mode, the left side controls affect the "Mid" signal in the matrix,
while the right side controls affect the "Sides" signal in the matrix.
Default: Stereo
A note on automation: When you automate settings in Stereo mode, your settings will be
saved for the specific channel (L or R) that you have selected, but will affect both L and R.
When you automate L and R to different values in Duo mode, you will need to delete your
settings for one of the channels (L or R) before you return to Stereo mode in order to avoid
conflicting values.
Waves BSS DPR-402
User Guide
12