Installing Equipment - D-Link DSR-1000AC Quick Start Manual

LED Color Status
Power / Orange/ Solid Orange
Status Green
Solid Green
Blinking
Orange
Blinking
Green
Light Off
2.4GHz/ Green Steady Green The link is good.
5GHz
Blinking
WLAN
Green
Light Off
USB Green Solid Green
Blinking
Green
Light Off
TX/RX Green Light Off
Status
Solid Green
Blinking
Green
LINK Green/ Light Off
Speed Orange
Solid Green
Solid
Orange
Table 2. Device Status LED Descriptions
DSR-1000AC Default Interface Settings
Ethernet Interface
Interface Type
LAN(1-портов 4 ) / Static IP
WLAN
WAN1 DHCP Client
WAN2 DHCP Client
(Configurable (default)
port)
Static IP
(When it's
configured
as DMZ)
Table 3. Default Interface Settings
Note: D-портов L ink Wireless AC Services Router only
allow Web GUI access from LAN and WLAN
interfaces by default for security reason. The
WAN2 is a configurable port which support
various and advanced scenario applications.
When WAN2 port is configured as DMZ port,
the IP address
172.17.100.254.
D-портов L ink Wireless AC Services Router
Description
Device during power-портов
on process.
Completion of power
on.
Device is crashed and
under recovery mode.
The system is
defective, such
firmware upgrades fail.
The device is power-портов
off.
There is activity on this
port.
No link.
The link is good.
There is activity on this
port.
No link.
No link.
Link present.
Port is sending or
receiving data.
Port is operating at
10Mbps.
Port is operating at
100Mbps.
Port is operating at
1000Mbps.
IP Address Web-Based
Management
192.168.10.1/24 Enabled
0.0.0.0/0 Disabled
0.0.0.0/0 Disabled
172.17.100.254/ Disabled
24
will be changed
Installing and Connection
This chapter describes how to install a DSR-портов
1000AC device in a standard 19-портов i nch equipment
rack and how to connect cables and power to
the device.
Before You Begin
Observe the following precautions to help
prevent shutdowns, equipment failures and
injuries:
-портов Before installation, always check that the
power supply is disconnected.
-портов Ensure that the room in which you operate the
device has adequate air circulation and that the
room temperature does not exceed 40 ºC
(104 ºF).
-портов Allow 1 meter (3 feet) of clear space to the
front and back of the device.
-портов Do not place the device in an equipment rack
frame that blocks the air vents on the sides of
the chassis. Ensure that enclosed racks have
fans and louvered sides.
-портов Correct these hazardous conditions before any
installation: moist
ungrounded or frayed power cables, or missing
safety grounds.

Installing Equipment

You can mount the DSR-портов 1 000AC device into a
standard 19-портов i nch equipment rack. To install an
appliance into a rack:
1. Attach the mounting brackets to each side of
the chassis as shown in figure 3 and secure
them with the screws provided.
to
Figure 3. Attaching Rack Mount Brackets
or wet floors, leaks,