About This Guide; Unpacking The Product; Product Overview - D-Link DSR-1000AC Quick Start Manual

About This Guide

This guide gives step by step instructions for
setting up D-портов L ink DSR-портов 1 000AC Wireless AC
Services Router. Please note that the model
you have purchased may appear slightly
different from those shown in the illustrations.

Unpacking the Product

Open the shipping carton and carefully unpack
its contents. Please consult the packing list
located in following information to make sure
all items are present and undamaged. If any
item is missing or damaged, please contact
your local D-портов L ink reseller for replacement.
-портов One (1) DSR-портов 1 000AC Wireless AC Services
Router
-портов One (1) Power adapter
-портов One (1) Console Cable (RJ45-портов t o-портов D B9 Cable)
-портов One (1) Ethernet (CAT5 UTP/Straight
Through) Cable
-портов One (1) Reference CD (CD-портов R OM containing
product documentation in PDF format)
-портов Two (2) Rack Mounting Brackets
-портов Three (3) Detachable Omni-портов d irection
antennas

Product Overview

Front Panel - DSR-1000AC
Figure 1. DSR-1000AC Front Panel
# Item
1 LED Power
(Top to Wireless AC Services Router is
bottom) powered on.
5GHz WLAN LED: A solid light
indicates
segment is ready. This LED
blinks
transmission.
2.4GHz WLAN LED: A solid light
indicates
segment is ready. This LED
blinks
transmission.
2 USB Port It can support various USB 1.1 or
2.0 devices below:
1. Flash Disk or Hard Disk for
network sharing.
2.
redundant.
3. Printer.
3 Gigabit LAN Connect Ethernet devices, such
port (1-портов 4 ) as
hubs.
4 Gigabit WAN Two auto MDI/MDIX WAN ports
port (1-портов 2 ) are
Ethernet cable to the cable or
DSL modem.
The WAN2 port is a configurable
port which can support WAN2 or
DMZ
connections or internal Server
Farm purpose.
5 Console Port Used to access Command Line
Interface (CLI) via RJ45-портов t o-портов D B9
console Cable.
Table 1. DSR-1000AC Front Panel Descriptions
Device Status LEDs and Ethernet Port
LEDs
Figure 2. Ethernet RJ-45 Port LEDs
The device LEDs show information about
current device status. When the device power
up, the POWER/STATUS LED will show solid
orange during power on process. Startup takes
one minute approximately to complete, the LED
will change to solid green. If you want to turn
the device off and on again, we recommend you
wait a few seconds between shutting it down
and powering it back. The Ethernet LEDs show
the status of each Ethernet port. Table 2 lists
the name, color, status and description of each
device LED.
D-портов L ink Wireless AC Services Router
Description
LED: Indicates the
that the wireless
during wireless data
that the wireless
during wireless data
3G Adaptor for WAN
computers, switches and
the connection for the
port for dual WAN