Table of Contents
Advertisement
FIG. 19: Do not operate the machine with the drive
shafts shields open or removed. Entanglement in rotating
drive shafts can cause serious injury or death.
Stay clear of rotating components.
Make sure rotating guards turn freely.
A loose yoke can slip off a shaft and result in injury to
persons or damage to the machine.
When installing a quick disconnect yoke, the spring
activated locking pins must slide freely and be seated in
the groove on the shaft. Pull on the driveline to make sure
the quick disconnect yoke can not be pulled off the shaft.
FIG. 20: When working on the machine, make sure the
header and reel are lowered all the way.
When it is necessary for the header or the reel to be in the
raised position, raise the header or reel all the way and
engage the cylinder stops, if equipped. See Cylinder
Stops in this section for more information.
m
WARNING: Always install the header lift
cylinder stops, if equipped, when working
near the header. Do not rely on the
hydraulic system to keep the header raised.
A sudden loss of hydraulic pressure could
cause the header to lower unexpectedly.
FIG.
21: Remove spilled oil, antifreeze or fuel
immediately from operator's ladder and platform and
other access areas.
Keep all access areas clean and free of obstructions.
700735917 D Rev.
FIG. 19
FIG. 20
FIG. 21
SAFETY
wc1941
WC1954
Wc1939
A-13
Advertisement
Table of Contents
