panthera BAMBINO 3 Assembly Instructions

TRAY-TABLE AND MAGNETIC HOLD BAMBINO 3
Tray table
Placement of the brackets under the tray table for different seating widths of the wheelchair.
Letters "A" and "B" are stamped in the brackets. Table seen from below.
1)
Width 24 cm. Use the inner holes for moun-
ting.
3)
Width 30 cm. Use the inner holes for moun-
ting. Note that the brackets have changed places
between left and right compared to fig 1 and 2.
5)
Turn the table over and screw in the screws.
Make sure that the screws are tightened into the
slot.
Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, +46-8-761 50 40, www.panthera.se
ASSEMBLY INSTRUCTIONS
Magnetic hold on rear wheel
Assemblu instructions:
Tray table and magnetic hold Bambino 3
art.nr. 6810000 Tray table
art.nr. 6810008 Magnetic hold
Max. load 5kg
Tools aquired:
Allen key 3 mm, Pliers
Cutter / scissors
2)
Width 27 cm. Use the outer holes for moun-
ting.
4)
Width 33 cm. Use the outer holes for moun-
ting. Note that the brackets have changed places
between left and right compared to fig 1 and 2.
6)
Place the table brackets in the holes in the
side guards as shown in the picture and push
down to the bottom.
art.nr. 8822126
Rev.2021-01