11.16
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar supports in the required position. Mount
and tighten screws
Guideline
Screw, handle-
bar holder
Info
Position the left and right handlebar holders evenly.
–
Position the handlebar.
F02950-10
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten screws
evenly.
Guideline
Screw, handlebar
clamp
Info
Make sure the gap width is even.
TUNING THE CHASSIS 11
1
. Take off the handlebar clamps. Take off
2
. Take off the handlebar supports.
2
.
M10
40 Nm (29.5 lbf ft)
M8
20 Nm (14.8 lbf ft)
®
Loctite
243™
1
53