Canadian Solar CS5AH-180M Installation Manual Of Replacement page 11

bolt class.
 In areas with heavy wind loads, additional mounting
points should be used. The system designer and the
installer are responsible for correctly calculating the
loads and ensuring that the supporting structure meets
all the applicable requirements.
Table: Approved bolting methods
Short frame four holes installation
method A
Short frame four holes installation
method B
Installation
Short frame
Method
four holes
Module installation
method A
Types
CS6AH
+5400Pa/-
2400Pa
CS6A-P-PLUS
CS6PH
CS6P-P-PLUS
CS6XH
CS6X-P-PLUS
Note: The installation method of bolt is based on the experimental results, "/" means not tested.
EN-Rev IM/GN-RM-EU/1.21P Copyright © June, 2021. CSI Solar Co., Ltd.
Inner four holes installation
Inner four holes installation
Short frame
four holes
installation
method B
+2400Pa/-
2400Pa
/ /
/ /
 Modules should be bolted at the following hole
locations depending on the configuration and loads:
method A
method B
Inner four Inner four
holes holes
installation installation
method A method B
+5400Pa/- +4000Pa/-
2400Pa 2400Pa
+5400Pa/- +4000Pa/-
2400Pa 2400Pa
/ /
Middle four holes installation
method A
Middle four holes installation
method B
Middle four Middle four
holes holes
installation installation
method A method B
/
/
+5400Pa/- +5400Pa/-
2400Pa 2400Pa
www.csisolar.com
/
/