GE RARWT Series Owner's Manual & Installation Instructions page 15

Testing the Thermostat
Furnace Test
1. Toggle mode button until furnace mode is active. Furnace
mode screen is displayed.
2. Adjust set temperature so it is 5 degrees above room
temperature. Within a few seconds, the furnace should initiate
its startup procedure.
3. Adjust the set temperature so it is 2 degrees below the
room temperature and the heat should turn off. Note:
Depending on the model of furnace used, there may be a
delay in engaging and disengaging the furnace.
49-5000400 Rev. 5
15