Honda CRF125F 2020 Owner's Manual page 107

RIGHT REAR
(10)
(8) lug
(9) slot
(10) brake panel
Installation
1. Reverse the removal procedure. Make sure
(8)
2. Adjust the drive chain (page 106).
3. Tighten the rear axle nut to the specified
4. Adjust the rear brake (page 89).
5. Apply the rear brake, release it, then spin the
(9)
If a torque wrench was not used to install the
wheel, see your dealer as soon as possible to
verify proper assembly. Improper assembly
may lead to loss of braking capacity.
the lug (8) on the swingarm is located in the
slot (9) in the brake panel (10). Check that
the chain adjusters are installed properly.
torque:
46 lbf·ft (62 N·m , 6.3 kgf·m)
wheel and check that it rotates freely. Repeat
this procedure several times.
Servicing Your Honda
Wheels
97