Reset To Factory Settings - ledlenser P5R CORE User Manual

4x
2x green blink: Backup Mode ON
2x red blink: Backup Mode OFF

Reset to factory settings

11
ON
1x blink
2x blink
hold
=5s
4x green blink: Reset
User Manual P5R Core | P5R Work V.01 06.2021
hold
=8s
If you tap the switch four times, the Backup Mode is
switched on or off (see also No. 8).
11. The lamp can be reset to factory settings. To do this,
switch on the lamp. Hold down the switch for about
eight seconds. The switch flashes once, then twice.
Release the switch when it has blinked twice.
Then press the switch again for five seconds until it
flashes four times. Now release the switch. The lamp
has been reset to the factory settings and can be used
again as usual.
10