Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for ledlenser P6R CORE
Summary of Contents for ledlenser P6R CORE
- Page 1 USER MANUAL P6R CORE P7R CORE...
- Page 2 Therefore, pay particular attention to the warning and safety instructions and properly dispose of the lamp, batteries and packaging material. P6R Core P7R Core User Manual P6R Core | P7R Core V.01 06.2021...
-
Page 3: Table Of Contents
Please register your product with the 12. Further Information enclosed registration card to obtain an extended warranty, check the authenticity of the product and receive updates about products or product improvements. User Manual P6R Core | P7R Core V.01 06.2021... -
Page 4: Scope Of Delivery
P6R Core: 18650 Li-ion, 3.7V (Item No. 501001) P7R Core: 21700 Li-ion, 3.7V (Item No. 502262) Rechargeable batteries may only be charged at temperatures from 10°C to 40°C. P6R Core Lanyard User Manual P6R Core | P7R Core V.01 06.2021... -
Page 5: Warning
Rechargeable batteries may only be charged at temperatures of 10°C to 40°C. Optionally, the batteries can be removed from the lamp and charged externally with a suitable charger. green green blink User Manual P6R Core | P7R Core V.01 06.2021... -
Page 6: Battery Replacement
If the „Memory Mode“ is deactivated, the lamp always <3s starts with the same light function. The „Memory Mode“ can be activated and deactivated in the advanced Low Power settings (10). User Manual P6R Core | P7R Core V.01 06.2021... -
Page 7: Boost Function
When the „Low Battery Warning“ is active, which can be activated or deactivated in the advanced settings, Backup the lamp gives a flashing signal every 15 minutes when the battery capacity is low. User Manual P6R Core | P7R Core V.01 06.2021... -
Page 8: Customizing Light Modes
These can now be activated 3x blink in the selected order by tapping the switch several times within three seconds after switching the lamp on. Strobe SAVE & EXIT User Manual P6R Core | P7R Core V.01 06.2021... -
Page 9: Additional Functions
2x red blink: Emergency Mode OFF This means that the lamp comes on automatically in the event of a power failure or is immediately active when it is removed from the holder. User Manual P6R Core | P7R Core V.01 06.2021... -
Page 10: Reset To Factory Settings
Then press the switch again for five seconds until it flashes four times. Now release the switch. The lamp has been reset to the factory settings and can be used 4x green blink: Reset again as usual. User Manual P6R Core | P7R Core V.01 06.2021... -
Page 11: Further Information
Simply scan the QR code or visit www.ledlenser.com. P6R Core P7R Core ledlenser.com Ledlenser GmbH & Co. KG Kronenstr. 5-7, 42699 Solingen Phone +49 212/5948-0 Fax +49 212/5948-200 info@ledlenser.com User Manual P6R Core | P7R Core V.01 06.2021...
Need help?
Do you have a question about the P6R CORE and is the answer not in the manual?
Questions and answers